DIMM-PC®/ETH+COM


Ethernet Module with two serial interfaces
  • Ethernet Part:
    Crystal LAN® CS8900 ISA Ethernet adapter
    IEEE802.3 compliant, half and full duplex
    10Mbps, selectable I/O-address
  • Serial Part:
    2 serial interfaces, 16550 compatible
    up to 115 kBaud, TTL signal levels
  • Power requirements: 5 Volt only power supply low power CMOS
  • Dimensions: 2.7 x 1.6-inch (68 x 40 mm )
  • And more...

Add to Info Request

Add to Compare



Overview
Specifications
Downloads

Full PC functionality at the size of a business card.

The DIMM-PC®/ETH+COM is an add-on module for the DIMM-PC® series. The Ethernet part is equipped with the Crystal LAN CS8900 ISA ethernet adapter from Crystal Semiconductor following the IEEE802.3 standard and supports half- or full-duplex operation in ISA Bus com-puters on 10 Mbps Ethernet networks.

The I/O controllers addresses are software configurable via DOS setup program. The serial part is equipped with the SMC 37C665 I/O-controller and adds two more serial ports to a DIMM-PC® system. The signals of the serial ports are available on the DIMM I/O connector in TTL levels. The customer can decide to use different types of interfaces (RS232, RS485, TTY etc.) by adding his own driver circuitry on his base board.

The DIMM-PC®/ETH+COM is designed for a 144-pin DIMM connector known from notebooks as memory socket. *Note that this connector is different to the used for the DIMM-PC®/CPU itself. The pinout of DIMM-PC®/ CPU and DIMM-PC®/ETH+COM are well considered, so an easy and short routing on the customers design is possible (a direct pin to pin connection).

Sales

Support

Info Request

Comparisons


Products Menu